• Gather your materials.
• Measure your wrist or the wrist of the person who will be wearing the bracelet. If you want your bracelet to fit loosely, add about ½ inch to that measurement to get the length of your bracelet.
• Lay out the bead configuration you want, and measure how long it is.
• Subtract the length of the bead configuration from the length of your bracelet. Divide that difference by two, and make a note of that number.
• Slide one side of the toggle clasp onto the cord. Fold over the cording and secure with a crimp bead. Cut off the excess.
• 
• Measure from the clasp along the cord the measurement that you got in Step 3. Place a crimp bead here.
• Slide on the rest of your beads and secure them with a crimp bead at the end.
• Measure from that crimp bead the measurement you got in Step 3. This is where you slide on the other end of the toggle clasp.
• 
• Secure the second toggle clasp piece with your last crimp bead as you did in Step 5. Trim any excess.
• Your bracelet is done!

To Use Your Lava Bead Diffuser Bracelet

• Place a drop of your favorite essential oil on one of the beads on the bracelet.
• Wait a few minutes for the oil to absorb into the bead before putting it on, to avoid staining your clothes.
• If you find that your lava beads are not very absorbent, either wipe them with a cotton ball soaked with nail polish remover or rough them up a little bit with an emery board.
• Some of the beads come with a waxy coating that prevents them from absorbing the oil.